Irrigation Manifold Assembly

At the same time that Tony and his crew were installing the pump and motor, my husband was busy assembling the irrigation manifold.

My husband made the assembly in three sections so that each section weighed approximately the same amount and will make it easier when it comes time to disassemble the system for storage during the winter. I'll walk you through the system beginning on the lower right hand side of the above picture.
First is the well and the blowout pipe on the ground. The wire that you also see in the picture below is for the pressure sensor:

On the scaffold, the first section of the irrigation assembly consists of the following:

The Y-strainer and a backflow preventer come next in the assembly.

The third section consists of the following two pictures. The disc filter and the continuous air vent:

With the manifold assembled, we are ready for the water!